Toro 36in Recycler Kit Installation Instructions page 2

Figure 1
3. Install the fasteners in the same holes that they
were removed from.
4. Remove the 2 bolts and nuts securing the
directional guard to the deck and remove the
guard (Figure 2).
Note:
Retain the guard for converting back to
side discharge.
Figure 2
3
Installing the Trailing Shield
Parts needed for this procedure:
1 Trailing shield
2 R-clamps
2 Bolt (5/16 x 3/4 inch)
g307772
Nut (5/16 inch)
Procedure
1. Locate the axle rod where the shield will be
installed (Figure
2. Install the R-clamps onto the rod. Ensure that
the R-clamps face the correct direction as shown
in Figure
g307773
3. Install the shield using 2 bolts (5/16 x 3/4 inch)
and 2 nuts (5/16 inch) as shown in
shield should be able to swing back and forth.
2
3).
Figure 3
4.
Figure 4
g307771
g307770
Figure 5. The