Heat Sink - HP Victus 16z-e000 Maintenance And Service Manual

Table 6-4 Card reader description and part number
Description
Card reader
Card reader cable
Before removing the card reader, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the left speaker (see
Remove the card reader:
1. Disconnect the card reader cable from the ZIF connector on the system board (1).
2. Remove the Phillips M2.0 × 2.5 screw (2) that secures the card reader to the computer.
3. Lift the back of the board up slightly, and then pull it into computer to remove it (3).
Reverse this procedure to install the card reader.

Heat sink

To remove the heat sink, use this procedure and illustration.
Table 6-5 Heat sink descriptions and part numbers
Description
Heat sink, 80 W
Heat sink, 60 W (models with NVIDIA graphics)
Heat sink, 60 W (models with AMD Radeon RX 5500M graphics)
Preparation for disassembly on page
Bottom cover on page
Battery on page 38).
Speakers on page 40).
37).
Component replacement procedures
Spare part number
M54771-001
M54772-001
33).
Spare part number
M54774-001
M54773-001
M84787-001
41