Sony PEG-NZ90 CLIE Handbook (primary manual) Handbook page 123

Performing a HotSync
6
Tap OK.
The HotSync screen is displayed.
Performing a LANSync operation
You can perform a LANSync operation when you have prepared your
computer setting, CLIÉ handheld setting, and Conduit Setup. Turn on the
computers and start the HotSync
Note
To perform a LANSync operation, both computers connected to the cradle and
performing a HotSync
HotSync
and make sure that Network in the shortcut menu is selected. If not, click Network to
check it.
1
Rotate the Jog Dial™ navigator to select the HotSync icon
and press the Jog Dial™ navigator on the Application
Launcher screen.
The HotSync screen is displayed.
Tip
You can also tap the HotSync icon to display the HotSync screen.
2
Tap the HotSync
A HotSync
The message will be displayed to note that the HotSync
complete.
Exchanging and updating data using a HotSync
®
(Other HotSync operations)
®
operation via LAN (LANSync)
®
Manager application.
®
are required to be set for LANSync. On each computer, click the
icon in the Windows task tray (bottom right-hand corner of the taskbar)
icon.
®
operation starts.
®
®
operation
operation is
123