Table of Contents
Advertisement
TROUBLESHOOTING
Your washing machine is equipped with various
automatic safety and feedback functions . They
enable failures and needed maintenance to be
detected and indicated accordingly .
PROBLEM
Washing machine does not start,
no indicators are on
Washing machine does not start,
although "Start/Pause" has been
pressed
Washing machine stops during
the programme, and "Start/Pause"
blinks
Detergent dispenser contains
detergent residues after
programme end
Washing machine vibrates during
spinning
50
These failures are frequently so minor that they can
be removed within a few minutes .
When a failure occurs, the sensing indicator in the
middle of the control panel may blink .
POSSIBLE CAUSE
Not connected to mains
Socket or fuse does not function
Power breakdown
Door not properly closed
Key lock is activated
The detergent dispenser is not
correctly inserted
Rinse hold (= positon of spin
button) is activated
Programme was interrupted,
maybe door has been opened
Safety system has been activated:
failure indicator lights up and/or
display shows failure (F...); water
tap might be closed
Inlet water pressure too low; mesh
filter of the water supply hose may
be blocked
Transport bolts have not been
removed (!)
Washing machine not standing
level on all four feet
SOLUTION
Insert plug into socket
Test function with a lamp, have
faulty part repaired
The washing machine will
automatically continue when
power is available again
Push door to close it until it clicks
shut
Press the button with the key
symbol at least 3 seconds to
deactivate the key lock
Completely push in the detergent
dispenser into the dispenser
compartment
Terminate Rinse hold with draining
the water or spinning the laundry
(see "Rinse hold" – FUNCTIONS
AND OPTIONS) .
Make sure door is closed .
Press "Start/Pause" to proceed with
the programme
Refer to paragraph "Failure
indicators" . Make sure that water
tap is open and inlet hose has no
kinks .
Make sure water tap is properly
opened . Check mesh filters of
inlet hose, see CLEANING AND
MAINTENANCE / Cleaning the
mesh filters of the inlet hose
Remove transport bolts according
to the instructions in the
INSTALLATION GUIDE
Adjust feet (INSTALLATION
GUIDE) . Make sure that washing
machine stands on level and firm
underground .
Advertisement
Table of Contents
