Whirlpool FSCR12441 Health & Safety, Use & Care And Installation Manual page 51

PROBLEM
Spin speed "0" blinks on control
panel and/or laundry still very wet
Spin result poor
Detergent residues on laundry
after wash
Washing machine stands still
during programme / programme
seems not to proceed / during
standstill, animation may appear
on display
Programme duration is longer or
shorter as initially indicated on the
display / in the programme chart .
POSSIBLE CAUSE
Unbalance of laundry load
prevented spin cycle, to protect
the washing machine
Spin button was set to a low spin
speed .
Unbalance during spinning
prevented final spin cycle .
Excessive foam formation
prevented spinning .
Too much powder detergent used
/ quality of detergent .
Programme phases without drum
movement .
Excessive foam formation (maybe
by overdosage of detergent)
interrupted the programme . Can
be repeated several times until the
foam reduction is sufficient .
Under- or overvoltage of mains
might be detected .
Washing machine adapts to factors
having an effect on duration, such
as size of laundry load, excessive
foam formation, load unbalance,
prolonged heating time due to
low inlet water temperature etc . .
When programme duration is
recalculated, an animation appears
on the display .
SOLUTION
If you want to spin the wet
laundry, add more laundry
items of different sizes and start
"Rinse&Spin" programme .
Avoid small laundry loads
consisting of few big, absorbent
pieces of laundry / wash different
sizes of articles in one load
Select and start "Spin" programme
with a higher spin speed (if
selectable) .
See line above .
Start "Rinse&Spin" programme .
Avoid excessive detergent dosing .
Adjust and use the Dosing Aid
function .
Avoid detergent overdosing .
Brush out the fabric .
Use "Intensive Rinse" option (if
selectable) .
Use liquid detergent / use special
detergent for black or dark laundry .
Standstill phases lasting up to
about 2 minutes are normal in
some wash programmes .
The programme continues
automatically, as soon as the foam
reduction is sufficient .
If display shows Fod (=failure
overdosage), refer to table FAILURE
INDICATORS AND MESSAGES .
Programme will automatically
continue as soon as the mains
voltage is in the proper range .
Avoid small laundry loads with
absorbent, big pieces of laundry /
add articles of different sizes .
Avoid detergent overdosing
– respect the dosing
recommendations of the detergent
manufacturer . Adjust and use the
Dosing Aid function .
EN
51