Advertisement
Software Installation
CardBus Enabler Installation
1. Insert the Belkin Software Installation CD into your
CD-ROM drive.
2. Launch the Belkin CardBus Installer.
3. You must now select the desired install location. Choose the
hard disk that contains your active Mac OS system folder.
Click "Install".
4. The installer will move the Cardbus Enabler into your
Mac OS system folder. Click "Quit".
5. Restart your PowerBook to enable the Belkin
CardBus Adapter.
6
Software Installation (continued)
FireWire Enabler Installation
If you are using Mac OS 8.6, you must download the Apple
FireWire software from the Apple support website. Apple
FireWire 2.4 is recommended. See instructions below to
download and install Apple FireWire software.
NOTE: Apple FireWire 2.5 will not install on Mac OS 8.6.
If you are using Mac OS 9.0 or Mac OS 9.0.4, it is not necessary
to download Apple FireWire to use the Belkin FireWire CardBus
Adapter. It is recommended, however, that the most recent
release of Apple FireWire software be used. See instructions
below to download and install the Apple FireWire software.
1. Go to website "http://www.apple.com/", then go to
"support" and from there to "downloads".
7
Advertisement
