Station Manager Port; Ethernet Interface Ports - Emerson PACSystems RX3i Quick Start Manual

Quick Start Guide
GFK-2948A
1.4.

Station Manager Port

The Station Manager Port is an RS-232 serial port intended to permit the user to
perform set-up operations or monitoring functions, but is not intended for
permanent connection. The Station Manager port provides a means to access the
module through a terminal interface. This function can alternatively be accessed over
the Ethernet network.
A Station Manager interface application can be downloaded from Emerson Global
Customer Care
https://www.emerson.com/Industrial-Automation-Controls/support.
1.5.

Ethernet Interface Ports

The module provides two auto-sensing 10BaseT / 100BaseTX RJ-45 shielded twisted
pair Ethernet ports for connection to either a 10BaseT or 100BaseTX IEEE 802.3
network. The port automatically senses the speed (10Mbps or 100Mbps), duplex
mode (half duplex or full duplex) and cable (straight-through or crossover) attached
to it with no intervention required. There is only one interface to the network (only
one Ethernet MAC address and only one IP address).
User Features
by searching KB14092 or
Section 1
Sep 2019
following the link
4