Sony WALKMAN WM-GX822 Operating Instructions Manual page 56

Notes
• If the power source is removed
during timer recording standby, the
setting is erased and timer
recording will not operate. In this
case, set the settings for timer
recording again.
• You can not listen to a tape during
the timer recording standby mode.
• Set the timer recording before one
minute of the recording time.
If the setting is completed less than
one minute before the recording
time, the timer recording function
will not operate.
Choosing a mode on
recording
At a private stage or recording
loud music, press MENU
repeatedly to set the cursor to REC
and then press SET, "LIVE" will
appear in the display.
When recording a business
meeting or a low level sound, press
SET and "LIVE" will disappear
from the display.
To prevent a tape from
being accidentally recorded
over
Break off the tabs from side A
and/or B. To reuse the tape for
recording, cover the tab hole with
adhesive tape.
Notes
• Do nopt use a CrO
metal (TYPE IV) tape, otherwise the
sound may be distorted when you
play back the tape, or the previous
recording may not be erased
completely.
56
(TYPE II) or
2
• Do not connect or disconnect the
headphones to 2REMOTE while
recording from the radio. The
recording condition may change
abruptly, or noise may be recorded.
• When recording with the
microphone, do not place it near a
lamp cord or a fluorescent lamp to
avoid interference noise.
• If a howling effect occurs, turn
down the volume.
• While recording, the p operation
only functions.
Using Other
Functions
To lock the controls
–Hold function
Slide HOLD in the direction of the
arrow to lock the controls of the
Walkman or the remote control.
To see the remote display in
the dark
Press LIGHT on the remote
control.
You can see the remote display in
the dark which provides
illumination by
electroluminescence(EL). The EL
display will glow for about 5
seconds for each press. The LIGHT
button on the remote will operate
even if the HOLD function is on.