Sony WALKMAN WM-GX822 Operating Instructions Manual page 54

Notes
• If you cannot complete step 3 or 4
while the indications are flashing,
repeat from step 2.
• If you preset automatically using
ASP, the stations stored will be
erased.
To cancel the stored station
Operate the unit according to the
steps in Storing Radio Stations
Manually and Receiving the Stations
from step 1 to step 3. Insted of
tuning in to a station, turn and
hold SPEED CONTROL•TIME/
TUNE–/SLOW or +/FAST until "-
---" is displayed. Then press
ENTER while "----" is flashing.
The maximum frequency or the
minimum frequency will be
displayed as "----".
Receiving Stations
Outside Japan
1 Press BAND•RADIO ON to
turn on the radio.
2
Press ENTER. The
frequency digits, "PRESET"
and a preset number flash in
the display.
3
Press and hold
BAND•RADIO ON until
"AREA 1" flashes in the
display.
4
While "AREA 1" is flashing,
press PRESET+/– repeatedly
to select either area "USA"
(USA, Canada, Central and
South America) or "Eur"
(Europe and other countries)
and then press ENTER.
54
5 Press and hold ASP until "1"
changes to "A" in the
display.
The Walkman starts
searching and storing
stations.
6
Press BAND•RADIO ON to
select the desired band and
press PRESET+/– to select a
station.
Recording
1
Insert a normal (TYPE I) tape
with the side facing forward
you want to record on.
2
Select a recording source:
To record with the
microphone
Connect the supplied
microphone to the MIC jack.
You can use the supplied
microphone stand.
To record from the radio
Tune in a station you want to
record (see "Listening to the
Radio" on page 52). When
recording FM or TV programs,
make sure the headphones are
plugged in as they serve as an
antenna.
3
Slide REC/PAUSE.
"REC" appears in the display
and recording starts after
about two seconds.
To record on both sides, insert
a cassette with the side to be
recorded on facing the cassette
holder.