Pentair STA-RITE SC-75P Installation Manual page 131

Connecting AC Power to the Power Center using an Automatic Timer
Connect AC power using an automatic timer to the power center as follows:
1. IMPORTANT WARNING: Be sure that the Power Center AC power line is switched OFF before connecting AC power to
the Power Center.
2. Use 12-14 AWG three conductor insulated wire for the main AC power connection. Connect the Power Center to pool
pump AC power source. The Power Center should be connected to the pump motor switch or automatic timer.
3. Attach incoming GROUND wire to the terminal block inside the Power Center (Green/Yellow wire). Connect Blue wire
to Neutral and Brown wire to Phase
5. Reinstall the Power Center cover and secure with the cover screw.
6. The Power Center installation is complete. For SC-75 operating information, refer to the SC-75 User's Guide.
Attach incoming power
wires from load center-
filter pump relay
(12-14 AWG 3wire) to
SC-75 Power Center AC
power wires
Conduit (PG Nut) for AC
power cable source
SC-75 Power Center (cover removed)
7