10 -Installation; Location Notes; Positioning And Water Connection; Electric Connection - Gaggia CONCETTO ER Operating Instructions Manual

10 - INSTALLATION
10.1

Location notes

The machine has to be installed in a dry and protected place, at
the following ambient temperature : 10° C - 40° C;
maximum humidity: 90%.
Lift the pallet in a way that the fixing screws A can be removed.
Following screw on the four supporting feet B.
10.2

Positioning and water connection

NOTE - Check if the surface where the machine is installed has
the adequate dimension and solidity to support the
machine safely.
Drill a hole in the support (A - F. 5).
Place the machine on the support and insert the electric power
cord (B - F. 5) in the hole (A).
Connect a drain tube to the coupling (C - F. 6) and fix it with a
rack clamp.
Connect (using tube and coupling made of food materials only)
the machine to the drinking water network, through the cou-
pling (D - F. 6).
We suggest supplying the machine with water treated
with a descaling device, above all in case of a high
calcium and magnesium content (hard water).
Place definitely the machine on the support (the circles E - F. 5,
indicate the suitable position of the adjustable feet).
Level off the machine using the adjustable feet (F - F. 6).
CONCETTO ER CONCETTO ER CONCETTO ER
CONCETTO ER CONCETTO ER
A
B
10.3
NOTE - In case of plants with a 400 V two-phase current, use
F. 7
34/124
E
MACHINE FRONT
E
F. 5
WARNING /IMPORTANT
For a correct and ergonomic use of the machine, it is
recommended to install it onto a surface which is at
least 1 m high.
F
B
F. 6

Electric connection

the two phases to supply the machine with 230 V single
phase current (F. 7). As for the 230 V single-phase
connection, require the special installation kit (code
%1034.R09).
Neutral (N) – Blue
Phase (L ) – Brown
1
Phase (L ) – Black
2
Ground – Yellow/green
Power cord type H07RNF
section 4x2,5 mm
English
E
A
E
C
D
2