Gaggia CONCETTO ER Operating Instructions Manual page 43

English
CLOCK
AUTOM. SWITCHING-ON
TIMES ON/OFF
COUNTERS
ANTI-FREEZING
UNBLOCK
AUTOM. SWITCHING-ON
This function enables the programming of automatic switching-
on and off of the machine, in two different time ranges, every
day of the week. By selecting:
- "ON", the function can be programmed .
- "OFF", the machine can only be switched on and off ma-
nually, through the main switch (18).
Any automatic switching-on and off times previously set,
remain stored anyway.
- To program the time ranges and the days see the following
function "TIMES ON/OFF".
NOTE - The automatic switching-on of the machine is possible
only if the main switch (18) is on the "I" position.
OFF
ON
ON 1: mtwtfss 00:00
OFF1: mtwtfss 00:00
ON 2: mtwtfss 00:00
OFF2: mtwtfss 00:00
ON 3: mtwtfss 00:00
OFF3: mtwtfss 00:00
ON 4: mtwtfss 00:00
OFF4: mtwtfss 00:00
COFFEE TOTALE 000000
WATER TOTALE 000000
ON
OFF
CODE: 0000
43/124
TIMES ON/OFF
This function enables to program the automatic switching-on
and off times over a whole week.
- By selecting "TIMES ON/OFF", the cursor blinks on the day
to be modified.
- Enter the day, using the button
letter into a capital one.
- Remove the day from the setting, using the button
turning the capital letter into a small one.
- Confirm the adjustment.
To set the time use the same procedure followed to set the clock.
Example: the function explanation scheme shows a machine
programming which schedules the machine switching-on at
08:00 and the switching-off at 18:00 from Monday to Friday.
The switching-on at 09:00 and off at 12:30 on Saturday, and a
stop over the whole Sunday.
COUNTERS
One of these two functions indicates the total number of coffee
brewing cycles; the other indicates the number of hot water
brewing cycles.
If the automatic dosing of hot water is disabled (see "HOT
WATER PROG." function), one cycle will be counted every time
the electrovalve is switched-on.
NOTE - Both functions cannot be reset and are just reference
functions.
ANTI-FREEZING
When the machine on "STANDBY" is exposed to low tempera-
tures, the anti-freezing function is important to prevent the da-
mages caused by icing-up in boilers. This function keeps the
boilers temperature at the minimum value to prevent freezing.
- By selecting "ON", the function is enabled.
- By selecting "OFF", the function is disabled.
NOTE - This function can only be enabled if also function
"AUTOM. SWITCHING-ON" is on and if the machine
is on "STANDBY". When the function is enabled the
message "ANTI-FREEZING"will be displayed.
UNBLOCK
This function enables to temporarily unblock the machine when
the number of cycles programmed for maintenance and desca-
ling has been reached. To get the unblock code refer to the firm
that has installed the machine or that supplies maintenance.
Then enter the code into the function:
- Select "UNBLOCK"; the cursor will blink under the first figu-
re to be modified;
- enter the datum and confirm;
- after every confirmation, the cursor blinks under the following
figure and goes on until the code is completed.
(down), turning the small
(up),
CONCETTO ER CONCETTO ER CONCETTO ER CONCETTO ER CONCETTO ER