Majestic QUARTZ Series Installation Manual page 65

3. LOG #2: Locate and install Log #2 by positioning the
right end of the log against the two rear right hand
bend tabs. The back right corner of the log will be
placed between these tabs. The left side of the log will
rest on Log #1. When installed correctly, the front face
of Log #2 should be flush with the front face of Log #1.
See Figure 5.
1
Figure 5. Install Log #2
4. LOG #3: Locate and install Log #3 by installing the
"right" end of the log over the left burner pin and press-
ing "down" to engage log pin. Rotate Log #3 coun-
terclockwise until it contacts the base pan edge as
shown in Figure 6.
1
3
BASEPAN EDGE BASEPAN EDGE
Figure 6. Install Log #3
Majestic • QUARTZ32IFTN/L, QUARTZ36IFTN/L, QUARTZ42IFTN/L Installation Manual • 2641-980 Rev. C • 9/20
HAND BEND TABS HAND BEND TABS
2
2
5. LOG #4: Locate and install the Log #4 by installing the
"left" end of the log over the right log pin and press-
ing "down" to engage the log pin. The face of the log
should contact the base pan edge. See Figure 7.
1
3
Figure 7. Install Log #4
6. Locate the glowing embers and install them as shown
in Figure 2. Do not install any glowing embers on the
back row of burner ports. Glowing Embers can be
placed directly over burner ports; however, for optimal
front flame height, place glowing embers around the
burner port clusters indicated by the "arrows" shown in
Figure 8.
WARNING! Risk of Explosion! Follow ember placement
instructions. Replace ember material annually. Improperly
placed embers interfere with proper burner operation.
1
3
Figure 8. Embers Installed
BASEPAN EDGE BASEPAN EDGE
2
4 4
2
4
65