Majestic QUARTZ Series Installation Manual page 62

2. Locate and install the left rear base log (1) by installing
the right end of the log over the log pin. Then rotate
the rear log until it contacts the rear left hand bend tab.
See Figure 4.
1
Figure 4. Install Left Rear Base Log
3. Locate and install the right rear base log (2) by posi-
tioning the right end of the log against the rear right
hand bend tab. The left side of the log will rest on the
left rear log. When installed correctly, there should be
approximately 1 inch between right rear log and back
of firebox. See Figure 5.
1 INCH GAP BETWEEN BACK 1 INCH GAP BETWEEN BACK
OF LOG AND FIREBOX BACK OF LOG AND FIREBOX BACK
1
Figure 5. Install Right Rear Base Log
4. Locate and install the left front base log (3) by install-
ing the "right" end over the left burner pin and pressing
"down" to engage log pin. The "left" side of this log
will be positioned by the front left hand bend tab. The
face of the log should contact the base pan edge. See
Figure 6.
Majestic • QUARTZ32IFTN/L, QUARTZ36IFTN/L, QUARTZ42IFTN/L Installation Manual • 2641-980 Rev. C • 9/20
62
2
1
3
BASE PAN EDGE BASE PAN EDGE
Figure 6. Install Left Front Base Log
5. Locate and install the right front base log (4) by install-
ing the "left" end over the right burner pin and pressing
"down" to engage the log pin. The "right" side of this
log will be positioned by the front right hand bend tab.
The face of the log should contact the base pan edge.
See Figure 7.
1
3
Figure 7. Install Right Front Base Log
6. Locate the glowing embers and install them as shown
in Figure 1. Do not install any glowing embers on the
back row of burner ports. Glowing Embers can be
placed directly over burner ports; however, for optimal
front flame height, place glowing embers around the
burner port clusters indicated by the "arrows" shown in
Figure 8.
WARNING! Risk of Explosion! Follow ember placement
instructions. Replace ember material annually. Improperly
placed embers interfere with proper burner operation.
1
3
Figure 8.
2
2
4
BASE PAN EDGE BASE PAN EDGE
2
4