Table of Contents
Advertisement
When using the dust bag, make holes in the abrasive
paper using the punch plate as follows:
1.
Set the tool upside down.
2.
Place the punch plate over the abrasive paper so
that the bent sides of the punch plate are flush
with the paper edges.
3.
Press the punch plate to make holes in the abra-
sive paper.
CAUTION:
•
Be sure to remove the punch plate before oper-
ating the tool.
Model BO4555 only
NOTE: Use Makita hook-and-loop sandpaper with
this sander.
1
► 1 . Velcro sandpaper 2. Base
1.
Set the tool upside down so that the pad is on top.
2.
Position the sandpaper to fit the shape of the
base. Be sure to align the holes on the sandpaper
with the holes on the pad (the dust will be sucked
into these holes; it is therefore important to leave
them open).
3.
Press the paper firmly over the pad.
To remove the sandpaper:
1.
Set the tool upside down so that the sandpaper is
on top.
2.
Grasping one corner of the sandpaper, peel it from
the pad.
NOTE:
•
If the sandpaper is in good condition, save it for
further use.
Dust bag (accessory)
► 1 . Dust bag
The use of the dust bag makes sanding operations
2
clean and dust collection easy. To attach the dust bag,
fit the bag's entry port onto the dust spout on the tool.
Make sure that the hole in the bag's entry port is just
over the pimple-like protrusion on the dust spout.
For the best results, empty the dust bag when it
becomes approximately half full, tapping it lightly to
remove as much dust as possible.
Installing paper dust bag
(accessory)
1
► 1 . Groove 2. Front fixing cardboard 3. Front side of
paper dust bag
Place the paper dust bag on the paper dust bag holder
with its front side upward. Insert the front fixing card-
board of the paper dust bag into the groove of the paper
dust bag holder.
Then press the upper part of the front fixing cardboard
in arrow direction to hook it onto the claws.
5 ENGLISH
2
3
1
Advertisement
Table of Contents
