OPERATION
Switchingonandoff
1
Press »ON/OFF« to switch the device on and off.
Radiooperation
For the best FM (VHF) reception, it is sufficient to extend
the telescopic antenna and direct it accordingly.
Selectingstoredstations
1
Select the station you want using the preset buttons
»1,2,3,4,5« (preset stations 1 to 5) or using
5« and the preset buttons »1,2,3,4,5« (preset
stations 6 to 10).
Adjustingthevolume
1
Adjust the volume using »
Adjustingthetone
1
Adjust the tone using »
Displayingthecurrenttime
1
Press »MODE« to briefly display the time.
– The display changes from the frequency to the
time and back.
Alarmmode
Alarmwithsignaltone
1
Press »ON/OFF« to switch off the device.
2
Set the alarm signal tone (»e«) on the right of the
§
device using
»e
3
Press »ALARM« to select the alarm function.
– Display: the current time and »e«.
4
Briefly press »MODE« to check the alarm time.
– Display: the set alarm time, »e« flashes.
– After a short time, the display changes to the cur-
rent time, »e« no longer flashes.
– The alarm goes on with a signal tone at the set
time.
16
ENGLISH
___________________________________________________________
+
VOL–«.
!
§
TONE
«.
«.
Alarmwithradiostation
1
Press »ON/OFF« to switch on the device.
2
Select the radio alarm (»
device using
3
Select the radio station using the preset buttons
2,3,4,5« or using »+5« and the preset buttons
»1,2,3,4,5«.
4
Set the alarm volume using »
»+
5
Press »ON/OFF« to switch off the device.
6
Press »ALARM« to select the alarm function.
– Display: the current time and »
7
Briefly press »MODE« to check the alarm time.
– Display: the set alarm time, »
– After a short time, the display changes to the cur-
rent time, »
– The radio switches on at the set alarm time.
Brieflydisplayingthealarmtime
1
With the device switched off, press »MODE«.
– The display changes from the clock to the set
alarm time, – display: »e« or »
– After a short time, the display changes back to the
current time.
Interruptingthealarm
1
Press »SNOOZE« while the alarm is sounding.
– Display: »e« or »
– The alarm (signal tone or radio) stops.
– The alarm goes on again at 5-minute intervals
(the total alarm time is 90 minutes).
Cancellingthealarmfortheday
1
Press »ON/OFF« while the alarm is sounding.
– Display: the current time and »e« or »
– The alarm (signal tone or radio) stops, but the
alarm function remains activated for the next day
at the set time.
Cancellingalarmstand-by
1
Press »ALARM« to cancel alarm stand-by.
– Display: »e« or »
– The set alarm time is saved.
2
Press »ALARM« to re-activate alarm stand-by.
– Display: »e« or »
§
«) on the right of the
§
»e
«.
+
VOL–«.
§
«.
§
« flashes.
§
« no longer flashes.
§
§
« flash.
§
« disappears.
§
«.
»1,
« flash.
§
«.