Xerox DOCUPRINT N4525 Service Quick Reference Manual page 235

Removal
1.
Remove the Duplex Module, if installed.
2. Remove the Multi-sheet Bypass Feeder Assembly (RRP 1-25).
3.
Remove the two machine screws (one at each end) securing the Multi-sheet
Bypass Feeder Top Cover to the Multi-sheet Bypass Feeder Assembly, and
remove the Top Cover by sliding it slightly toward the Bin.
4.
Disconnect the P/J107 that runs from the Tray Assembly to the Feeder
Assembly (the three wire connector residing adjacent to the Tray Spring.
5.
Remove the screw securing the Tray Spring and free the Spring.
6.
Push out on the Front Support as you slightly bow the Bin, and release the
pivot hole on the right side of the Tray from the metal shaft on the Front
Support.
7.
Remove the Multi-sheet Bypass Feeder Tray Assembly.
Volume 1 / Print Engine - FRU RRPs 1-213