Elation ARTISTE MONDRIAN User Manual page 26

S Y S T E M M E N U
PERSONALITY - Reset Default (011)
ONLY QUALIFIED TECHNICIANS SHOULD PERFORM THIS FUNCTION!
SAVED WHITE BALANCE IS ERASED AFTER RESET IS PERFORMED.
This function restores all fixture settings to the factory default settings. The password is 011 and must
be entered each time a reset is performed.
EFFECT ADJUST – Test Channel
Auto test each individual channel function independently from the DMX control board.
EFFECT ADJUST – Manual Control
Select and manually test and fine adjust each individual channel function Independently from DMX
control board. This function will center PAN and TILT motors and set dimmer to 100%. PAN and TILT
functions will still operate if the fixture needs to be positioned to a flat clear surface. With the
individual functions, you can focus the light on a flat surface (wall) and perform fine adjustments.
EFFECT ADJUST – Calibration
ONLY QUALIFIED TECHNICIANS SHOULD PERFORM THIS FUNCTION!
This function allows small adjustments to be made to the Pan, Tilt, and Zoom movements to
compensate for ware or in the event a sensor has been knocked slightly out of place.
Because improper use of this function can result in undesired operation this function has been
password protected. The password is 050 and must be entered each time the calibration menu
function is entered. Because calibration is an extremely delicate procedure, instructions on
performing this action are left out of this manual. For a first-time calibrator, please contact our
customer support team for step-by-step instructions.
EDIT PROGRAM – Rec. Controller
The fixture features an integrated DMX-recorder that can be used to transmit programmed scenes
from the DMX-controller to the moving head. Adjust the desired scene numbers (from – to) via the
encoder. When the scenes are called at the controller, they will automatically be transmitted to the
moving head.
EDIT PROGRAM – Record Controller – Working with Built-In Programs
A Primary unit can send up to 3 different data groups to the Secondary units, i.e. a Primary
unit can start 3 different Secondary units, which run 3 different programs. The Primary unit
sends the 3 program parts in a continuous loop.
The Secondary unit receives data from the Primary unit according to the group which the Secondary
unit was assigned to. If e.g. a Secondary unit is set to "Secondary 1" in the menu "Set to
Secondary", the Primary unit sends "Auto Program Part 1" to the Secondary unit.
If set to "Secondary 2", the Secondary unit receives "Auto Program Part 2".
26