Honda HRX217K6HYA Manual page 59

ROTO-STOP®/DRIVE BELT
5. Measure the clutch spring free-standing height:.
Clutch spring
If the spring measures less than the service limit or
appears damaged, replace the spring.
6. Inspect the blade holder bearing and the ball plate
bearing. Rotate and check for smooth operation. Replace
any damaged bearings.
When installing the bearings, be sure to only press on the
outer bearing race during installation.
7. Check the clutch spring for abnormal wear or damage.
Replace the spring if any abnormal wear is found.
Make sure the spring contains a rubber tube inside of it.
This rubber tube is required for vibration dampening.
4-6
Service limit
6.8 mm (0.27 in)
HRX217HYA • HRX217HZA
6.8 mm
(0.27 in)
BALL PLATE BEARING
BLADE HOLDER
BEARING
CLUTCH
SPRING