Table of Contents
Advertisement
Installation
Oven Assembly
DOUBLE SECTIONS:
1. Double section ovens may be secured to the
stand with the same procedure as above utiliz-
ing the same four bolt holes on the bottom of
the oven.
2. Secure double stacked units together using
fastening brackets and bolts provided.
3. Seal the seam between the top and bottom
ovens with an NSF listed splash zone sealant.
4. A steam vent will be installed on each unit to
vent the ovens.
Figure 5
ADJUSTMENTS ASSOCIATED WITH INITIAL
INSTALLATION:
Each oven, and its component parts, have been
thoroughly tested and inspected prior to ship-
ment. However, it is often necessary to further
test or adjust the oven as part of normal and
proper installation. Such adjustments asso-
ciated with initial installation are the responsi-
bility of the dealer or installer. Since these ad-
justments are not considered defects in
material or workmanship, they are not covered
under the Original Equipment Warranty. They
include, but are not limited to calibration of the
solid state temperature control, adjustment of
the doors, leveling, testing of electrical compo-
nents, and tightening of fasteners. No installa-
tion should be considered complete without
proper inspection and, if necessary, adjust-
ment by qualified installation or service per-
sonnel.
8
Advertisement
Table of Contents
