Troubleshooting Guide - Blodgett ZEPHAIRE 50E Installation Operation & Maintenance

Electric convection oven
Hide thumbs Also See for ZEPHAIRE 50E:
Table of Contents

Advertisement

Troubleshooting Guide

POSSIBLE CAUSE(S)
SYMPTOM: Elements will not heat
Oven not plugged in.
S
Power switch on the control panel is off.
S
Control set below ambient temperature.
S
Doors are open.
S
SYMPTOM: Oven does not come to ready.
The oven has not reached preheat temperature.
S
Internal problem with main temperature control.
S
SYMPTOM: Convection fan does not run.
Oven is not plugged in.
S
Circuit breaker tripped.
S
Doors are open
S
SYMPTOM: General baking problems.
Thermostat out of calibration.
S
Improper oven venting.
S
*Denotes remedy is a difficult operation and should be performed by qualified personnel only. It is recommended, however, that
All repairs and/or adjustments be done by your local Blodgett service agency and not by the owner/operator. Blodgett cannot as-
sume responsibility for damage as a result of servicing done by unqualified personnel.
WARNING!!
Always disconnect the power supply before cleaning or servicing the oven.
Maintenance
SUGGESTED REMEDY
Plug in electrical supply cord.
S
Set the control panel to COOK or OVEN ON.
S
Set to desired cook temperature.
S
Close doors.
S
Wait for oven to reach preheat temperature.
S
*
S
Plug in electrical supply cord.
S
Reset the breaker.
S
Close doors.
S
*
S
*
S
13

Advertisement

Table of Contents
loading

Table of Contents