The Water Inlet Hose And Water Filter; Connecting The Water Inlet Hose And Water Filter - Baumatic TITAN2 Instruction Manual

4) Place the top hinge cover back into position and using a
screwdriver, fully tighten it to the top of the cabinet.

The water inlet hose and water filter

o The water pressure should be 2 bar or higher to allow the
icemaker to operate correctly.
o Care should be taken to make sure that the water inlet does not
come into contact with any hot surfaces.
o The water filter only filters the water; it does not eliminate
bacteria or microbes.
o The water filter life will depend on how often you dispense water
and ice. We recommend that the water filter is replaced at least
every 6 months.
o IMPORTANT: The water inlet MUST be connected to your cold
water supply.

Connecting the water inlet hose and water filter

2) At the rear of the appliance, you will eventually connect a holder
which you will clip the water filter into (on the right or left hand side).
o You should measure an appropriate distance from the tap along
the water inlet hose and mark a position where you will want to
place the water filter.
o IMPORTANT: Put the water filter in a position where it will be
able to clip into the holder that you will position on the rear of
the appliance.
1) Place the seal inside of
connector A and then screw
connector A securely onto your
cold water mains supply. Push
the water inlet hose firmly onto
connector A.
35