Appendix A: Alphabetical Parameter List - Siemens SITRANS LG200 Series Instruction Manual

Appendix A: Alphabetical Parameter
List
NOTE: Parameters described in the following are dependant on probe type.
Default values may change according to probe type. This will assist with
set-up of the SITRANS LG200 with pre-programmed, application specific
defaults.
Users should check all parameters for validity before returning the unit
into operation.
Parameter Name
20 mA Setpoint (Set 20 mA) (100%* reference point)
Default: 120 in, 396.3 gal (User password)
4 mA Setpoint (Set 4 mA) (0%* reference point)
Default: 0.0 in, 0 gal (User password)
7ML1305-1 Correction (factory authorized personnel only)
Default: 0.0 (Superuser password)
Blocking Distance (BlockDis)
Default: 0 cm (User password)
Compensate (Compsate) (factory authorized personnel only)
Default: None (Superuser password)
Conversion Factor (Conv Fct) (factory authorized personnel only)
Default: 985 (Factory password)
Damping (Damping)
Default: 0 sec. (User password)
Volume Units (Vol Units)
Default: gallons (User password)
Level Units (LVL Units)
Default: inches (User password)
Loop Control (Loop Ctrl)
Default: Level ((User password)
Measurement Type (MeasType)
Default: Lvl Only (User password)
Derating Function (Lvl only) (factory authorized personnel only)1
Dielectric (Dielctrc)
Default: 10 - 100 (probe dependent) (User password)
Display Factory Parameters (Disp Fact)
Electronics Temperature (Elec Temp) (factory authorized personnel only)
Fault Output (Fault)
Default: 22 mA (User password)
Page 72 SITRANS LG200 – INSTRUCTION MANUAL
Page Number
65
65
71
66
70
69
65
62
60
64
60
70
63
69
71
65
7ML19985KA02