Kenwood NX-300 Service Manual page 110

NX-300
Item
Panel tuning mode
6. Low RSSI 1) Adj item: [An
at –118dBm LRSSI]
adjust *7 Adjust: [✳✳✳]
2) Adj item:
[Analog [AnL LRSSI]→
Narrow] [AnL' LRSSI]→
[AnC LRSSI]→
[AnH' LRSSI]→
[AnH LRSSI]
Adjust: [✳✳✳]
SSG output:
–118dBm (0.28µV)
(MOD: 1kHz/±1.5kHz)
[Analog 1) Adj item: [Aw
Wide] LRSSI]
Adjust: [✳✳✳]
2) Adj item:
[AwL LRSSI]→
[AwL' LRSSI]→
[AwC LRSSI]→
[AwH' LRSSI]→
[AwH LRSSI]
Adjust: [✳✳✳]
SSG output:
–118dBm (0.28µV)
(MOD: 1kHz/±3kHz)
[NXDN 1) Adj item: [Nv
Very LRSSI]
Narrow] Adjust: [✳✳✳]
2) Adj item:
[NvL LRSSI]→
[NvL' LRSSI]→
[NvC LRSSI]→
[NvH' LRSSI]→
[NvH LRSSI]
Adjust: [✳✳✳]
SSG output:
–118dBm (0.28µV)
(MOD: 1kHz/±1.5kHz)
*7: Because Low RSSI at –118dBm (NXDN Narrow) is adjusted by adjusting Low RSSI at –118dBm (Analog Narrow), it is not necessary to adjust
Low RSSI at –118dBm (NXDN Narrow).
110
ADJUSTMENT
Condition
PC test mode
equipment
1) Adj item: [Low RSSI SSG
(Analog Narrow)]
2) Adj item: [Low],
[Low'], [Center],
[High'], [High]
SSG output:
–118dBm (0.28µV)
(MOD: 1kHz/±1.5kHz)
1) Adj item: [Low RSSI
(Analog Wide)]
2) Adj item: [Low],
[Low'], [Center],
[High'], [High]
SSG output:
–118dBm (0.28µV)
(MOD: 1kHz/±3kHz)
1) Adj item: [Low
RSSI (NXDN Very
Narrow)]
2) Adj item: [Low],
[Low'], [Center],
[High'], [High]
SSG output:
–118dBm (0.28µV)
(MOD: 1kHz/±1.5kHz)
Measurement
Test-
Unit Terminal Unit
Panel ANT
Universal
connector
Adjustment
Specifi cations /
Parts Method
[Panel tuning mode]
After input signal
from SSG, press
[ ] key to store the
adjustment value.
[PC test mode]
After input signal
from SSG, press
[Apply] button to
store the adjust-
ment value.
Adjust with the ana-
log signal.
Remarks