Table Of Contents - Stanley ProSet XT1 Blind Rivet Tool Instruction Manual

ENGLISH
© 2017 Stanley Black & Decker, Inc.
All rights reserved.
The information provided may not be reproduced and/or made public in any way and through any means (electronically or mechanically) without
prior explicit and written permission from STANLEY Engineered Fastening. The information provided is based on the data known at the moment of
the introduction of this product. STANLEY Engineered Fastening pursues a policy of continuous product improvement and therefore the products
may be subject to change. The information provided is applicable to the product as delivered by STANLEY Engineered Fastening. Therefore,
STANLEY Engineered Fastening cannot be held liable for any damage resulting from deviations from the original specifi cations of the product.
The information available has been composed with the utmost care. However, STANLEY Engineered Fastening will not accept any liability with
respect to any faults in the information nor for the consequences thereof. STANLEY Engineered Fastening will not accept any liability for damage
resulting from activities carried out by third parties. The working names, trade names, registered trademarks, etc. used by STANLEY Engineered
Fastening should not be considered as being free, pursuant to the legislation with respect to the protection of trade marks.
CONTENT
1. SAFETY DEFINITIONS ...............................................................................................................................5
1.1 GENERAL SAFETY RULES .............................................................................................................................................................5
1.2 PROJECTILE HAZARDS..................................................................................................................................................................5
1.3 OPERATING HAZARDS ..................................................................................................................................................................6
1.4 REPETITIVE MOTIONS HAZARDS ..............................................................................................................................................6
1.5 ACCESSORY HAZARDS .................................................................................................................................................................6
1.6 WORKPLACE HAZARDS ................................................................................................................................................................6
1.7 NOISE HAZARDS .............................................................................................................................................................................7
1.8 VIBRATION HAZARDS ....................................................................................................................................................................7
1.9 ADDITIONAL SAFETY INSTRUCTIONS FOR PNEUMATIC POWER TOOLS .................................................................7
2. SPECIFICATIONS .........................................................................................................................................8
2.1. TOOL SPECIFICATIONS ...................................................................................................................................................................8
2.2 PLACING SPECIFICATIONS ............................................................................................................................................................9
2.3 THE PACKAGE CONTENTS .............................................................................................................................................................9
2.4 MAIN COMPONENTS LIST ..........................................................................................................................................................10
2.5 STANDARD NOSE EQUIPMENT .................................................................................................................................................10
3. TOOL SET UP .............................................................................................................................................11
3.1 NOSE EQUIPMENT (Ref. fi g. 2)...................................................................................................................................................11
3.2 AIR SUPPLY (Ref. fi g. 3.) ...............................................................................................................................................................11
3.3 PRINCIPLE OF OPERATION .........................................................................................................................................................12
4. OPERATION PROCEDURE .........................................................................................................................13
4.1 TOOL OPERATION (Ref. fi g. 1, 4, 5, 6) ......................................................................................................................................13
4.2 EMPTYING THE MANDREL COLLECTOR. (Ref. fi g. 1) .........................................................................................................13
5. SERVICING THE TOOL ...............................................................................................................................14
5.1 MAINTENANCE FREQUENCY .....................................................................................................................................................14
5.2 NOSE EQUIPMENT ........................................................................................................................................................................14
5.3 DAILY SERVICING ...........................................................................................................................................................................14
5.4 WEEKLY SERVICING ......................................................................................................................................................................14
5.5 PROTECTING THE ENVIRONMENT ...........................................................................................................................................14
6. EC-DECLARATION OF CONFORMITY .......................................................................................................15
7. PROTECT YOUR INVESTMENT! ................................................................................................................16
7.1 POP®Avdel® BLIND RIVET TOOL WARRANTY .......................................................................................................................16
7.2 REGISTER YOUR BLIND RIVET TOOL ONLINE. ......................................................................................................................16
4
Original Instruction: C - 19/300