Sharp KS-18EV Service Manual page 10

1. Remove the body in accordance with "REMOVE OF BODY".
2. Disconnect the lead wire from heater plate ass'y and remove the screw holding temp. fuse angle.
3. Remove the temp. fuse ass'y from the temp. fuse angle.
4. Now the temp fuse ass'y is free.
Note : When reassembly take care so that the charged part of temperature fuse assembly does not protrude
from the TUBE-TA and securely fi x it to the temperature fuse angle and then fi x it with a screw to the
outer pot.
Outer pot
1. Detach the dew receiver from the upper ring.
2. Insert the fl at type screwdriver or similar into the gap between the upper ring and the hinge cover,
remove the hinge cover.
3. Fixing the handle shaft by using pliers, remove the handle shaft from the lid ass'y.
4. Now the lid ass'y is free.
Body
REMOVE OF TEMP. FUSE ASSEMBLY
Fig. 10
REMOVE OF LID ASSEMBLY
Handle shaft
Hinge cover
Flat type screwdriver
TRS angle
Pliers
Upper ring
Fig. 11
10
Temp. fuse
Temp. fuse angle
Screw
Hammer
Lid cover