IBM System i Manual page 28

|
Table 3. System i requirements - LAN card location (continued)
| | | Model
| |
|
| | |
800, 810
| | | 820
| | |
825
|
| | | 830, SB2
| | |
840, SB3
| | | 870, 890
1
|
Note: These locations will only be available if the Integrated Ethernet Port is not operational.
|
To review cable requirements, see the Operations Console cable requirements topic.
Related tasks
"Changing the console from a local console directly attached to a local console on a network (LAN) in
a non-partitioned or primary partitioned system" on page 67
To change from an Operations Console with local console directly attached to a local console on a
network (LAN), follow these steps on the system, using the existing console.
"Changing the console from a local console directly attached to a local console on a network in a
logical partition" on page 67
To change from an Operations Console with a local console directly attached to a local console on a
network (LAN), follow these steps on the system using the existing console.
"Changing the console from a twinaxial console to an Operations Console in a non-partitioned or
primary partitioned system" on page 73
To change from a twinaxial console to an Operations Console, you must use the existing console to
perform these steps on the system.
"Changing the console from a twinaxial console to an Operations Console in a logical partition" on
page 74
To change from a twinaxial console to an Operations Console, you must perform these steps on the
system using the existing console before turning off the system or performing an initial program load
(IPL).
Related reference
"Scenario: Consoles for multiple systems or partitions" on page 10
This scenario discusses a situation in which you want to manage multiple systems or partitions.
"Preparation for your network environment" on page 11
To prepare for your network environment, you need to identify and comply with the minimum
network configuration required to set up an Operations Console local console on a network (LAN)
configuration.
"Operations Console cable requirements" on page 21
You need to meet these cable requirements for supported models, cables and card locations.
"Operations Console software requirements" on page 21
You need to meet these software requirements for working with Operations Console.
"Changing from a local console directly attached to a local console on a network (LAN)" on page 66
To change from an Operations Console with a local console directly attached to a local console on a
network (LAN), you must change settings on both the PC and the system.
"Changing from a twinaxial console to an Operations Console" on page 73
To change from a twinaxial console to an Operations Console, you need to perform a set of steps on
both the PC and the system.
20
System i: Connecting to System i Operations Console
Operations Console (LAN) console
card location
C06, second C05
C04, second C03, third C11
Integrated Ethernet Port, (C03, C02,
(1)
C01)
C04, second C06, third C10
C04, second C06, third C10
C04, C06, C07, C08, C09
Operations Console direct
connection (asynchronous) location
for the cable
C07
C06
C06
C02
C02
C02