Initial Operation - IVT ESD-280 Instruction Manual

Hide thumbs

Table of Contents

Available languages

Instruction manual

ATTENTION! DANGER OF ELECTRIC

SHOCK!

Consider working area environment. Do not expose

power tools to rain. Do not use power tools in damp

or wet locations. Keep work area well lit and dry. Try

to prevent the device from getting wet or being

exposed to humidity. Do not leave it outside

overnight. Water entering a power tool will increase

the risk of electric shock.

∙

The power supply cable should be checked

regularly and, before using it, make sure the cable is

not damaged or worn out. If the cable is not in good

condition, do not use the appliance; take it to an

authorized service Center.

∙

When tool is used outdoor, only use an extension

cable that is suitable for outdoor use and which is

marked for this specific use. Keep it away from the

working area, from damp, wet or oily surfaces and away

from heat and flammable materials.

∙

Avoid any accidental starting: make sure that the

power switch (if present) is in the «off» position, before

plugging the tool in.

∙

Remove adjusting keys or wrenches before turning

the tool on.

∙

Do not use the tool if the switch does not turn the

tool on or off. Any tool that cannot be controlled with the

switch is dangerous and must be repaired.

WARNING! During the use of certain

power tools, some dust containing

chemicals known to cause cancer,

may occur.

Some of these chemicals are: lead from lead based

paints, crystalline silica from bricks and cement and

other masonry products, arsenic and chromium from

chemically treated lumber and other dangerous

products. If dust is present, your risk from these

exposures varies, depending on how often you do this

type of work. To reduce your exposure to these

chemicals, any time you do pulverulent operations,

work in a well ventilated area and work with

approved safety equipment, such as dust masks

that are specially designed to filter out microscopic

particles.

∙

If the appliance strikes a foreign body, examine the

device for signs of damage and carry out any necessary

repairs before restarting and continuing to work.

∙

If the appliance starts to vibrate abnormally, turn

it off and check for the cause immediately. Vibration is

generally a warning of trouble.

∙

Always switch off the appliance and wait until

the device completely stops whenever you leave

the

machine,

before

before changing accessories, checking, cleaning,

troubleshooting or working on the appliance.

∙

It is forbidden to move or modify any of the internal

parts of the device.

Specific safety rules

∙

Hold the tool firmly by its handle, while operating.

∙

Before drilling holes or screwing into a wall, check

with a metal / voltage detector that you are not breaking

into electricity, gas or water supply line.

∙

Be sure you always have safe footing, when

working on floors, ladders and scaffoldings.

∙

Secure the workpiece. Use clamping devices or a

vise to hold the workpieces securely.

∙

Before switching the tool on, make sure there are no

keys, spanners and adjusting tools inserted in the machine.

∙

When working do not allow the electromotor to stall

under load.

∙

Do not touch the bit or the workpiece immediately

after operation: they may be extremely hot and could

burn your skin.

∙

Before you lay down the electric screwdriver make

sure that all moving parts have completely stopped.

UNPACKING

When unpacking, check to make sure that all

components are included. Refer to the drawings on this

manual. If any parts are missing or broken, please call

an IVT assistance center.