Table of Contents
Advertisement
Chapter 4. Inserting T17 Transducers into the Pipe
4.3 Connecting an XAMP (cont.)
8. Place the
XAMP
it. Ensure that the cables of the
reduce stress and strain on the joint. The
freely around the
9. Place the cover of the junction box over top of the
Engage the set screw to discourage tampering or removal (see Figure 87 below).
Note: To disconnect or uninstall the
72
body into the junction box (see Figure 86 below), resting the puck gently on the cables below
XAMP
rest naturally according to the slant at which they exit the epoxy, to
.
XAMP
Figure 86: Junction Box Cap
Figure 87: Set Screw on Junction Box
from the assembly, just reverse the procedures above.
XAMP
should remain still, and the cap of the junction box should rotate
XAMP
XAMP
and tighten the cover until the unit is closed and secure.
Model T17 Installation Guide
Advertisement
Table of Contents
