Physical Key Operation - Honeywell X-618 Operation Manual

Slide down the screen from the top can close the task list.

Physical Key Operation

Users can configure the extension key module X-K8 or X-K4 as required. These key modules are
connected with the X-NPMS by the special wiring. Each button can be configured as:

Task
It includes audio source, policy and zones, supports one-click broadcast and broadcast
operation combined with zones button. The name of keys can be written or printed on left card.

Volume Control
Keys can be set to adjust the step value of volume, select the zones and groups. Users need
to set different keys to turn up or turn down the volume. The button cannot be keeping pressed
to adjust volume. The device does not support the volume control function for X-DCS2000.

Zones
Keys can be set as zones for broadcast.

Groups
Keys can be set as groups for broadcast.
Steps for task broadcast:
1. Press zone or group button, the button indicator will flash. Users can choose more than one,
re-press to cancel.
Press the task button to broadcast. If the task doesn't contain any zones or groups, device will
2.
broadcast on all manageable zones. If the task contains zones, device will broadcast on
configured zones or selected zones. The button indicator in green means the normal task is
being broadcasted, red means the emergency task is being broadcasted. The off indicator
means there is no task broadcasted.
3. Physical key can be configured with two trigger mode: press and toggle. Press mode means
users need to press the key to broadcast, release the key to stop. Toggle mode means users
need to press the key to broadcast, re-press to stop. The one-click key doesn't support press
mode.
4. Re-press the task key, the task will be finished.
Users can click the volume button to adjust the volume. The indicator will light after adjust the
volume. If the light is off, showing the operation is invalid.
Task Interface
25