Zone Selection; Zone Monitoring; Time Delay Cancellation; Volume Control - Honeywell X-618 Operation Manual

Zone Selection

A zone is selected by pressing the button that represents the zone. Press the selected zone button
again to deselect the zone.
Press the ALL button on the DCS front panel to select all zones, and press this button again to
deselect them.
Note:
Only the enabled zones which have been set in the Config software are selectable.
Zone state indicator lights have the following meanings:

A solid orange light indicates the zone has been disabled or has short-circuited.

A flickering orange light indicates the zone has an open circuit.

Green light indicates that the system is broadcasting.

Red light indicates the system is broadcasting fire emergency information.

A flickering green light indicates the zone has been selected. When the light is off this indicates
the zone is either not selected or is not in use.

If a zone is selected and no other operation is performed for more than one minute, the zone
indicator light automatically returns to its original state.

Zone Monitoring

The DCS can monitor sound being broadcast in certain zones. Perform the following steps to
monitor sound being broadcast in particular zones:
1. Press and hold to the MONITOR button until the following step 2 has finished.
2. Select the needed zone to be monitored. The monitoring loudspeaker plays the sound being
broadcast in the selected zone.
The DCS can only monitor one zone, and the system automatically cancels the previous zone
that has been selected if another zone is selected. Repeat the above operations can monitor
the other zones.
3. Press the MONITOR button again to stop zone monitoring.

Time Delay Cancellation

When the DCS is performing the time delay task and in the delayed state, the delay indicator light
turns on. If the play task is to be performed immediately, then the time delay needs to be cancelled
by pressing the DELAY button. When the button is pressed, the equipment automatically initiates
playing.

Volume Control

Note:
Note that the number of selection is the order of channel.
The output sound volume of the built-in speaker can be adjusted by pressing combinations of
buttons simultaneously. Press the "Fn" button and
button and
Use buttons, X-NPMS and X-SMART to manage or configure the software to adjusting the output
sound volume of the amplifier and zones. The operation is shown as below table:
can turn up.
can turn down the volume, and the "Fn"
3