DSU ProxyServer User Guide
5
Pry the shunt out of the RS232 position, and insert it in the V.35 position.
RAM Sockets
Figure 2-4. Shunt Positions
Note: if you wish to make changes to the 8-position DIP switch, do so at this time. For
details on DIP switch settings, refer to the previous section,
6
Align the board with the guide slots on the inside of the chassis and carefully slide the
board back into the chassis.
7
Being sure to support the back panel, turn the ProxyServer over again, and replace the
cabinet mounting screw.
8
Turn the ProxyServer right-side-up again and proceed to the nect section to connect the
cables.
14
8-Position DIP Switch
LEDs
Back Panel Connectors
V.35 Shunt Position
RS232C Shunt Position
8-Position DIP
Swtich.