AT&T Merlin 206 User's Card page 4

Custom Feature Programming (For FEATURE PACKAGE 1)
Also Refer to USER'S GUIDE Programming Section and Index
Assigning Features to Buttons
Activate
Feature Codes
If you want to assign features to more than one programmable button, remain in program mode until finished—there is
Note:
no need to go in and out of program mode for each button assignment.
Changing a Number on Outside Auto Dial Button
Outside Auto Dial
If you want to change more than one Auto Dial button, you can do it in one changing sequence and don't need to go
Note:
in and out of program mode for each.
Programming Special Functions in an Outside Auto Dial Sequence
Pause: Automatic Dialing will
pause for 1.5 seconds
Stop: Automatic dialing will stop
until button is touched again
Flash (or "Switchhook" Flash)
for PBX, Centrex and Custom
Calling Features
Programming Auto Dial for An Additional Long-Distance Service
Outside Auto Dial
Use this button for access to the long distance service. Program individual telephone numbers on separate buttons.
Note:
Programming Automatic Line Selection
To Specify Order of
Automatic Line Selection
Note: You may program some, all, or none of your lines for Automatic Line Selection. Also, you must always re-enter program
mode before programming Automatic Line Selection.
Changing Line Ringing on Calls from Outside
Change How or Whether
Each Line Rings
Once you've completed your programming, remember to label all buttons
USER'S CARD
Enter program mode by sliding T/P switch to P position (ringing)
button Dial feature code
switch to center position
AUTO ANSWER
DO NOT DISTURB
PRIVACY
LAST NUMBER
SAVED NUMBER
PAGE
INTERCOM AUTO DIAL = * 6 + Intercom number
OUTSIDE AUTO DIAL
Enter program mode by sliding switch T/P switch to P position (ringing)
Dial button Enter new telephone number
position
Touch HOLD (pause)
Touch DROP (stop)
Touch RECALL
Enter program mode (ringing]
not already an Auto Dial button)
Enter authorization code (usually 5 or 6 digits)
Enter program mode (ringing)
(for no auto line selection omit this step)
Enter program mode [ringing)
touching until desired light code appears:
= RING
RED ON
RED FLASH = DELAYED RING
= NO RING
RED OFF
Leave program mode
MERLIN is a trademark of AT&T
© Copyright 1984 AT&T. Printed in U.S.A.
Issue 3, June 1984
999-502-135 IS
Dial number (if required) Leave program mode by sliding T/P
= *70
= *71
= *72
= *73
= *74
= *66
= *90 + Outside number
Leave program mode by sliding T/P switch to center
Touch botton to be programmed
Enter local telephone number (7 digits)
Leave program mode
Dial two stars ** Touch outside line buttons in desired order
Dial two stars**
Touch outside line button (note red light signals)
Touch a programmable
Touch Outside Auto
Dial *90 (if
Touch DROP (stop)
Leave program mode
Repeat