APRILIA Pegaso 650 2005 Manual page 50

PEGASO 650
Automatic switch-off
The automatic switch-off of direction indicators is required. If
vehicle is stopped, so with speed equal to zero, the direction
indicators carry on flashing indefinitely; if the vehicle is in
motion, the indicators switch-off automatically when one of
the following two conditions is true:
•
After a set time t = 40 sec.
After covering 500 m.
Immobilizer
The immobilizer system is integrated in the instrument panel
electronic board. Board
instrument panels without immobilizer, or with immobilizer
function disabled, so that they can be used in countries
where immobilizer system is not allowed or not fitted.
The supplier shall have the instrument panel immobilizer
device homologated according to the standards of the
relevant Ministries of the various countries and shall stick the
suitable label indicating
instrument panel itself.
Operation
The instrument panel reads key code upon switch-on. If this
code matches one of the memorised codes, the instrument
panel shall perform the initial check routine and enable
engine start.
The system should be able to store up to four keys.
If the key code is not acknowledged, the instrument panel
should inhibit engine starting and the display should show
manual override code request. In this case it should be
possible to gain access to the menu via the diagnosis
functions.
Code
This function allows immobilizer manual override through a
code. In case the instrument panel does not acknowledge
inserted key, access code is requested with the message:
•
Insert the code
The code should be made of 5 digits, 0 to 9. At line output,
code will be empty (5 digits equal to 0, i.e. 00000) and will be
programmed by the user, upon switch-on an alarm message
should be displayed for 10 seconds, until code is entered:
•
Remember to insert your user code
This code can be changed by the user, in this case the old
code should be entered and if the user loses the access
code, it can be changed through a procedure requiring
insertion of both keys.
design allows manufacturing
system certification on
GENERAL TECHNICAL INFORMATION
the
2 - 31