Additional Remote Function ( Channel 3 ) - Audiovox PRO9549FT3 Owner's Manual

more seconds. The alarm will immediately sound.
2. To stop the alarm, press and hold the ARM / DISARM button on the transmitter
again for 3 seconds. If the button is not pressed, the alarm will automatically
stop after 30 seconds.
NOTE : All normal transmitter functions will operate in the panic mode.
OPTIONAL DEVICE OUTPUT ( CHANNEL 2 )
Controlled By: Option 1 Button,
This security system is equipped with an on board relay which will activate when the
appropriate transmitter button is depressed for 4 seconds. Optional devices that may be
connected to this channel are;
Remote Electric Trunk Release
Remote Car Starter
Remote Window Closure
Remote Garage Door Interface
If your vehicle is not equipped with an electronic trunk release switch, or other option listed,
this feature may have been connected to another accessory. Please ask your dealer for
further information.
To remotely operate the device indicated, press and hold the appropriate transmitter button(s)
as indicated above.

ADDITIONAL REMOTE FUNCTION ( CHANNEL 3 )

Controlled By: Option 1 Button,
This security system has an additional feature that can be connected to a number of
different optional accessories. Some of the more common uses for this channel are;
Remote Car Starter
Remote Window Closure
Remote Garage Door Interface
To remotely operate the device indicated, momentarily press, or press and hold the
appropriate transmitter button(s) as indicated above.
The transmitters with your alarm may have Icons instead of words to reference functions of
your unit. If your transmitter has any of the Icons shown below, their function is as follows.
The Lock/Unlock Icon, shown on the left, would be used to Arm/Disarm your
system. Locking would take place when the system was armed and Unlocking
would take place when the system was disarmed.
The Open Trunk Icon, shown on the left, is used to open the vehicles electric
trunk release. Press this button for 3 seconds to open the trunk.
The Key Icon, shown on the left, is used to activate the remote start option which
may have been added to your vehicle. Press this button one time to remotely start
your vehicle. Pressing this button again while the vehicle is running under the
control of the remote start device will cause the vehicle to shut off.
Option 2 Button, or Both Option Buttons
Option 2 Button, or Both Option Buttons
Page 9