Selecting Reverse Gear - R; Switching Off The Engine And Vehicle System - Ferrari SF90 STRADALE 2020 Owner's Manual

"N" (Neutral) request
In any driving modes (electric or hybrid), pull both UP and DOWN
paddles towards the steering wheel at the same time without pressing the
brake pedal to request neutral "N". If necessary, "N" can be requested at
any speed. Subsequently, if an "UP" or "DOWN" shift is requested in the
driving modes that the gearbox is used in, the system will engage the gear
most suited to the speed of the vehicle.
During prolonged stops with the ICE running, we recommend putting the
vehicle into "N" (neutral).
Important note
If you allow the vehicle to move forward in "N", when "UP" or
"DOWN" is requested, a gear will be engaged that corresponds to the
speed of the vehicle.
Stopping the vehicle
When the vehicle stops, the system automatically engages 1st gear unless
Neutral has already been requested. When the vehicle is stationary while
the engine is running, keep the brake pedal depressed until you are ready
to move off again.

Selecting reverse gear - R

Reverse is a function performed by the front electric axle only.
If the high voltage battery is not sufficiently charged, the power needed
to engage reverse is guaranteed by the rear power unit consisting of an
electric motor and the ICE.
To select reverse gear, pull the LH lever of the gear selector towards R and
release it so that it goes back into its initial position. The letter
in the gearbox area of the instrument panel and R lights up in red on the
selector to indicate that reverse has been selected.
Reverse gear must always be selected when the vehicle is stationary and
the brake pedal pressed.
Important note
When reverse is selected, an acoustic safety signal beeps intermittently
as long as "R" (reverse) is engaged.

Switching off the engine and vehicle system

Switching off/stopping the engine
Warning
Press ENGINE START/STOP on the steering wheel to activate the
ENGINE STOP function: if the electric units are in operation, they
are deactivated and if the engine is running, it is switched off.
If the traction units have to be stopped while the vehicle is in motion,
R appears
press and hold the ENGINE START/STOP button for at least 2 seconds:
alternatively, press the button rapidly 3 times in succession.
Roadside Recovery
1
51