Ferrari SF90 STRADALE 2020 Owner's Manual page 20

Table of Contents

Advertisement

or the front/rear lid is open or not closed properly and is therefore not
protected by the perimeter surveillance function. If this is the case, check
that the doors and front/rear lids are closed properly and close any door or
lid that is open without deactivating the alarm system: the turn indicators
will flash once to indicate that the door or front/rear lids are now closed
properly and protected by the perimeter surveillance.
Warning
If the turn indicators and the red LED on the dashboard flash 9 times
when the alarm system is activated and the doors and front and rear
lids are properly closed, it means that the self-diagnostic feature has
detected a malfunction in the system. Contact the F
N
to have the system checked.
ETWORK
Deactivation
From outside the vehicle, press button
alarm system:
the turn indicators flash twice;
the system beeps twice;
the red LED
B
on the dashboard goes out;
the ceiling lights come on;
the central door locking system of the vehicle is deactivated and the
doors are unlocked.
Pressing button
C
twice unlocks the doors and the luggage compartment
and also turns on the low beams for 30 seconds. The alarm system is
deactivated and you can now get into the vehicle and perform a KEY-
ON.
By pressing button C, other functions, in addition to the anti-theft system,
are deactivated: see the "Vehicle keys" chapter for more information.
Deactivating the anti-lift alarm
Roadside Recovery
20
S
ERRARI
ERVICE
A
on the key once to deactivate the
Press button
D
on the roof panel dome light to deactivate the anti-lift
function of the alarm system. When this function is deactivated, the LED
on the button will flash for about 3 seconds and will then turn off.
Alarm memory
If, when the vehicle is started, a pop-up with the CODE symbol
appears on the instrument panel for 10 seconds after the system diagnosis
cycle, together with the message "Break-in attempted", this means there
has been an attempt to break into the car, causing the alarm to activate.
In this case, the system uses flashing codes displayed with the red LED
on the dashboard to indicate the cause triggering the alarm, according to
the following priority:
LED off twice: anti-lift sensor alarm
LED off three times: door alarm
LED off four times: luggage compartment lid alarm
LED off five times: ignition key alarm
When the engine/motors are switched on, the alarm system memory is
reset.
Flat remote control battery
D
B

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents