Connecting The Video System - Dometic PerfectView CAM360 Installation Manual

Connecting the video system

9 Connecting the video system
A
NOTICE!
• The lines for terminal 15, left indicator, right indicator and reverse
must be secured on the vehicle side with a fuse rated no higher than
3 A. If this is not the case, then an additional fuse must be used at the
corresponding consumer point.
• If the connection
be insulated. The load of this output must not exceed 150 mA.
I
NOTE
Lay the camera cable so that, should you need to remove the camera,
you can access the plug connection between the camera and the exten-
sion cable easily.
➤ Connect the video system as shown in the connection diagram (fig. c, page 7).
➤ Insulate the plug of the camera adapter cable with the included vulcanising adhe-
sive tape (fig. i, page 9).
Key for the connection diagram
No. in
fig. c,
Description of the connection
page 7
1 Monitor
2 Cameras
3 DC-DC converter
4 Controller
5 USB input
6 Black plug: Infrared receiver for the remote control
7 Yellow plug: Video output
8 Black plug ("FRONT"): Front camera
9 Black plug ("LEFT"): Left camera
10 Black plug ("RIGHT"): Right camera
11 Black plug ("REAR"): Rear camera
12 Slot for SD card
26
"MONITOR CTRL OUT" is not used, the copper end must
CAM360
EN