Adjust Swb Project/Workspace Settings For Automatic Debugger Start At Swb Start; Setup Debug Environment - Fujitsu F2MC-8L Series Application Note

Softune Workbench Automatic Debugger Start
Chapter 2 Preparation of the SWB
Figure 3: Dialog opened via Setup -> Development... (selecting Workspace-Tab).
2.1.3 Adjust SWB Project/Workspace settings for automatic debugger start at SWB
start
A Softune Workbench workspace can be configured to start the debugger using the last
selected .sup-file when the workspace was opened by the Softune Workbench. To select
this configuration one has to open the according configuration dialog via the Softune
Workbench menu Project -> Setup Workspace and check the option "Start Debugger" under
"Debug when workspace is open" (please refer to Figure 4).

2.1.4 Setup Debug Environment

When creating the new Softune Workbench Project/Workspace "my_swb_project" a default
debug environment my_swb_project.sup was created (please refer to the "debug"-folder in
the project view of the Softune Workbench). The settings of this .sup-file have to be adjusted
to the corresponding debugger tool (simulator or emulator debugger) and the behaviour of
the debugger tool at debugger start has to be setup following the instructions in dialog
opened when right-klicking the my_swb_project.sup and selecting the menu option
"Change..." (please refer to Figure 5).
© Fujitsu Microelectronics Europe GmbH - 9 - MCU-AN-300097-E-V11