Removing The Non-Fabric Processor From The Processor And Heat Sink Module - Dell EMC PowerEdge C6420 Manual

Next steps
1 Install the processor and heat sink module.
2 Install the sled into the enclosure.
3 Follow the procedure listed in
Related link
Installing a processor and heat sink module
Installing a sled
Removing the non-fabric processor from the processor and
heat sink module
Prerequisites
NOTE: Only remove the processor from the processor and heat sink module if you are replacing the processor or heat sink. This
procedure is not required when replacing a system board.
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the sled from the enclosure.
4 Remove the air shroud.
5 Remove the processor and heat sink module.
Steps
1 Place the heat sink with the processor side facing up.
2 Insert a flat blade screwdriver into the release slot marked with a yellow label. Twist (do not pry) the screwdriver to break the thermal
paste seal.
3 Push the retaining clips on the processor bracket to unlock the bracket from the heat sink.
Figure 34. Loosening the processor bracket
4 Lift the bracket and the processor away from the heat sink, and place the processor connector side down on the processor tray.
5 Flex the outer edges of the bracket to release the bracket from the processor.
After working inside your system.
Safety instructions.
Before working inside your system.
Installing and removing system components 87