Dell EMC PowerEdge C6420 Manual page 119

Figure 63. Installing system board
Next steps
1 If not installed, install the Trusted Platform Module (TPM). For information about how to install the TPM, see the Installing the Trusted
Platform Module section. For more information about the TPM, see the Trusted Platform Module section.
NOTE: The TPM plug-in module once installed is attached to the system board and cannot be removed. In the event of
a system board replacement, a TPM plug-in module is provided along with the system board for all systems that have a
TPM.
2 Reconnect all the disconnected cables.
3 Replace the following components:
a Air shroud
b Expansion card risers
c Processor heat sink module
d Memory modules
e OCP card
f Mezzanine card
g Linking board
4 Follow the procedure listed in
5 Import your new or existing iDRAC Enterprise license. For more information, see Integrated Dell Remote Access Controller User's
Guide, at Dell.com/esmmanuals.
6 Ensure that you:
a Use the Easy Restore feature to restore the Service Tag. For more information, see the Easy restore section.
b If the Service Tag is not backed up in the backup flash device, enter the Service Tag manually. For more information, see the
Entering the Service Tag section.
c Update the BIOS and iDRAC versions.
d Re-enable the Trusted Platform Module (TPM). For more information, see the Re-enabling the Trusted Platform Module (TPM)
section.
After working inside your system.
Installing and removing system components 119