Siemens SIPROCESS GA700 Quick Start Manual page 57

1. Prepare the Ethernet cable:
Figure 5-12
– Strip the Ethernet cable
– Insert the Ethernet cable through the cable gland. Make sure that the exposed shielding
– Screw down the cable gland
2. Fasten the prepared gland at the position
Figure 5-13
Connecting the Ethernet cable
1. Strip the end of the cable.
2. Assemble stripped cores in a FastConnect plug.
3. Insert the Ethernet plug in the service interface of the processing module. You must feel
for the position of the interface.
Quick Start
Compact Operating Instructions, 05/2015, A5E31805656-03
①
Cable gland
② ④
Contact shielding
③
Ethernet cable
⑤
Shielding braid
Ethernet cable shielding
a length of approx. 1 cm.
braid rests on the shield contact
⑥
Cable gland plate
⑦
Position of cable gland of Ethernet cable (device bottom)
Ethernet cable: Position of the cable gland
③
at the desired location so that the braid
② ④
or .
⑦
on cable gland plate (device bottom).
Connecting
5.1 Electrical connections
⑤
is exposed over
57