Table of Contents
Advertisement
Extended Menu
• You are projecting on a matte white diffusion screen that is flat and even.
• The projector is placed so it squarely faces the screen, not at an angle.
• Nothing is blocking the optional external camera and the projected image.
• Projection size is between 80 to 200 inches.
Projector ID
Extended > Multi-Projection > Projector ID
s
You can set the projector to a particular ID number which allows you to use a
remote control to individually control projectors. This is useful when you
want to control multiple projectors using one remote control.
• You need to set the remote control's ID to match the projector's ID
to operate only a particular projector.
To set the remote control's ID, set the remote control [ID] switch to
a
On. Press the [ID] button on the remote control and press the
numeric button that matches the projector's ID within 5 seconds.
(Enter a one-digit or two-digit number.)
• If you do not know the projector's ID, press the [ID] button during
projection to temporarily display the projector's ID and the remote
control's ID on the screen.
• You can set up to 30 IDs.
Projector Grouping
Extended > Multi-Projection > Projector Grouping
s
You can create a group of projectors that you can control simultaneously.
Tiling
Extended > Multi-Projection > Tiling
s
You can project the same image from up to 9 projectors to create one large
image using the Tiling feature.
Tiling
Set to Auto to configure tiling automatically.
If you do not install the optional external camera or tiling the images
automatically was unsuccessful, select Manual, and then select the Layout
and Location Setup settings individually.
Layout
Select the number of rows and columns you are setting up.
Location Setup
Select the position of each projected image as follows:
• Row Order to layout the screens from top to bottom, starting with 1 at
the top, in sequential order.
• Column Order to layout the screens from left to right, starting with A
on the left, in alphabetical order.
Location Info
You can view the name, IP address, and ID of the projector you set.
• Auto is available only when the optional external camera is installed.
• Make sure nothing is blocking the optional external camera while
a
performing automatic tiling.
• Do not change any of the projector names or IP addresses, or the
images will not be adjusted automatically.
Edge Blending
Extended > Multi-Projection > Edge Blending
s
You can blend the border between multiple images to create a seamless
screen.
Edge Blending
Set to On to enable the Edge Blending feature.
When not projecting images from multiple projectors, select Off.
96
Advertisement
Table of Contents
