Installing A Lff Drive Carrier Module - Seagate Exos AP 4U100 Installation And Maintenance Manual

Installing a LFF drive carrier module

1. Release the drive carrier handle by pressing the latch in the carrier handle towards the handle hinge as shown below.
Figure 88 LFF drive carrier module in open position
2. Identify the drive slot in the enclosure in which you want to insert the drive. Refer
drive slot numbering.
3. Insert the drive carrier module into the enclosure chassis, above the appropriate drive slot. Make sure that the drive is
held vertically with the carrier latch positioned at the top, and the carrier hinge is toward the back of the enclosure as
shown in Figure
Figure 89 Installing a LFF drive carrier module
4. Slide the drive carrier fully into the disk slot until the handle fully engages. The camming foot on the carrier will
engage into a slot in the enclosure. You should hear a click as the latch handle engages and locks it.
5. Verify that the amber Fault LED on the disk module handle is OFF. Verify that the front panel LED states show no
amber module faults.
89.
Figure 14 (page 30) to understand
Replacing a drive module 105