Figure 5-20. Capture Settings - Texas Instruments ADS1x15V2EVM-PDK User Manual

www.ti.com
5.2.2.5 Capture Configuration Settings
A slide-out menu is viewable on the right side of the Chart window. By clicking the slide-out for Show Capture
Settings, various configurations display and are selectable (as shown in
drop-down menu Capture Settings are:
• Select data rate for the data output conversion rate
• Select MUX channels by choosing the desired input channels to be converted
• Select FSR for choosing the voltage input measurement range
5.2.3 Configuration
The Register Map window
data from the ADS1x15. The Conversion register contains the value of the last 16-bit conversion result read from
the ADS1115. For the ADS1015, the conversion data are 12-bit left-justified in the 16-bit register.
Because the ADS1x15 is a programmable device, the Config, LoThresh and HiThresh registers are
programmable and 16 bits in length.
A number of control buttons and drop-down menus exist to configure the Register Map read and write operations
when data are written and read from the ADS1x15.
Question mark icons (?) appear throughout the Register Map window. Clicking these icons opens details
pertaining to the items in the locations where they appear.
SBAU362 – MARCH 2021
Submit Document Feedback

Figure 5-20. Capture Settings

(Figure 5-21) contains information about the configuration and the last conversion
Copyright © 2021 Texas Instruments Incorporated
ADS1x15V2EVM-PDK GUI
Figure 5-20 in the green box). The
ADS1x15V2EVM-PDK User's Guide 25