Cover And Front Bezel; Removing The Left Side Cover - HP x4000 Technical Reference Manual

Cover and Front Bezel

Removing the Left Side Cover

WARNING
For your safety, never remove the Workstation cover without
first disconnecting the power cord from the power outlet and
removing any connection to a telecommunications network. If a
Power Protection Device is fitted to your Workstation, you must
shut down your computer through the operating system, then
remove the power cord before removing the Workstation's cover.
Remove the Power Protection Device cables before any servicing
operation. Always replace the cover before switching the
Workstation on again.
To remove the cover (Figure 10-1):
1. Turn off the display and shut down the Workstation. Disconnect all
2. If necessary, unlock the cover on the back of the Workstation.
3. Unscrew the two thumb screws located at the back of the Workstation
4. Standing at the back of the Workstation, slide the cover towards you,
Chapter 10
This manual downloaded from http://www.manualowl.com
power cables and any LAN or telecommunications cables.
until they release. You may need to use a T15 Torx driver. The thumb
screws do not need to be completely removed to remove the cover.
tilt it open, then lift it off.
Installing or Replacing Parts and Accessories

Cover and Front Bezel

145