Table of Contents
Advertisement
Transport protection
Before the machine is used, the three trans-
port protection devices should be removed
as shown below.
Each transport protection device consists of
a screw, a washer, and a rubber spacer. After
the protection device has been removed, the
rubber spacer acts as a plug for the holes for
the device and also as a damper.
• First remove the screws and the washers.
• Then remove the rubber spacers.
1
• Finally, the rubber spacers should be
turned over and replaced in the transport
protection device holes.
32
Important!
In order to prevent the machine from being
damaged when transported, use the transport
protection device, which locks the entire inner
compartment in place. If the transport protec-
tion device is missing, you can order one from
your retailer.
Item number:
8064206-UL Rubber spacer
8901037 Bolt
8061767 Washer
Order three of each item!
Customer Care Center
1-800-898-1879
www.askousa.com
Advertisement
Table of Contents
