Settings In The Input Setting Screen - Tascam DR-44WL Reference Manual

4 – Recording
• When connecting to or disconnecting a condenser micro-
phone from the EXT MIC/LINE IN jack, confirm that the
phantom power for that jack is OFF. If you connect or
disconnect a microphone while phantom power is being
supplied, that microphone and this unit could be damaged.
• Turn phantom power ON only when using a condenser
microphone that requires phantom power.
• Supplying phantom power to some ribbon microphones
will break them. If you are unsure, do not supply phantom
power to a ribbon microphone.
• When using USB bus power, the unit might not be able to
supply phantom power depending on the computer. If this
occurs, use the dedicated AC adapter (TASCAM PS-P520U:
sold separately).
• Some condenser microphones will not operate when
phantom power is set to +24V.
• Do not connect or disconnect the AC adapter when using
phantom power. Even when the battery were inserted in
the unit, the power might be cut off, causing data being
recorded to be damaged or lost.
20
TASCAM DR-44WL

Settings in the INPUT SETTING screen

The contents of the INPUT SETTING screen displayed by
pressing the INPUT button vary depending on which mode to
be selected between 4CH mode and MTR mode.
INPUT SETTING screen TRACK 1 display when in 4CH mode
INPUT SETTING screen TRACK 1 display when in MTR mode
NOTE
When a channel (track) link is turned on, the link status
shown at the bottom of the INPUT SETTING screen will
change.
INPUT SETTING screen TRACK 1 display when in 4CH mode