Table of Contents
Advertisement
Installation
5.1 Connecting the Mounting Legs to the Drone
1
Disconnect the drone's
landing gear joints from the
airframe by releasing the three
connection screws.
2
Replace the three original
M-200 screws with the
ParaZero longer screws (six
total). On the screws, make
sure to place the washer first
and then the spring washer
above it before inserting the
screws into the landing gear
joints.
3
Pass the screws through the
holes in the M-200 legs, and
connect them to the drone.
Each M-200 leg has an R/L
indication on the inner side.
Be sure not to swap between
them.
Notice
SafeAir™ M-200 Pro Installation Guide
For Matrice 210 V2 – Spacers for the legs are needed.
9
5
www.parazero.com
Advertisement
Table of Contents
