6.12.3 To set the wireless connection
To confirm the wireless LAN connection status
ATXM20~35R2V1B + ATXM50R2V1B + ATXM20~35R5V1B
Daikin room air conditioner
4P518786-6F – 2020.06
2 Search for Daikin Residential Controller.
3 Follow the directions on the screen to install.
There are two options to connect the wireless adapter with your smart device.
▪
Connect the wireless LAN to your smart device directly.
▪
Connect the wireless LAN to your home network. The wireless LAN will
communicate with your smart device in your home network using a modem,
router or a similar device.
For more information and FAQ refer to:
http://www.onlinecontroller.daikineurope.com/.
1 Stop operation before setting the wireless connection.
2 Use the user interface to select the wireless LAN setting menu.
Note: Always aim the user interface at the signal receiver on the unit when
operating the user interface.
Menu
Description
Connection status check
WPS connection setting
AP mode/RUN mode (SSID + KEY) connection setting
Reset to factory default
Wireless LAN OFF
1 On home screen menu, press and hold
is not operating.
Result: The SP (wireless connection setting menu) appears. is blinking.
(5 sec.)
2 Press
to confirm the selection.
Result: is blinking.
3 Check the operation and timer LEDs on the indoor unit display.
ON/
OFF
a
Operation LED
b
Timer LED
If operation LED... ...and timer LED...
blinks
blinks
a
b
...then wireless LAN is...
not connected
6
Operation
|
for at least 5 seconds while the unit
User reference guide
35